|
Ultronix manufactures new Solvent Recovery Stills we also carry Used Stills. These Stills can be purchased separately or as part of a complete system including a Vapor Degreaser, Solvent Recovery Still, and/or a Water Chiller.Model
HD15 SOLVENT
RECOVERY STILL
Dimensions:
30” front to back, x 20” side to side, x 50” high.
Fabrication: 14
- 12 gauge stainless steel. The
top of the main distillation tank, and water separator will be sealed and
vented to the top of the degreaser (under the low temp coils).
This will eliminate the possible pressure build up in the Still,
and residual vapor will be recovered in the degreaser (under the
refrigeration unit). Included
are all the safety controls for proper operation of the Still with
customer’s choice of solvent (The same controls that are used for the
degreaser). A magnetic pump
assembly (1/25 HP pump motor) is installed on the boiling sump of the
Degreaser and Still unit to “PUMP OUT” contaminated solvent when
required. The boiling sump
and the Still sump are on the same level and will not require a pump for
transfer. The return
distilled solvent is gravity fed back into the degreaser storage tank.
A valve is installed between units for boil down of distillation
unit.
The picture above is our Model HD-15 (15 GPH) Addition Still sizes are
available: HD-30 (30 GPH.) HD-60
(60 GPH.) HD-100 (100 GPH)
Some of the Used Solvent Recovery Stills available are manufactured by Baron Blakeslee, Branson, and Chemmaster. Refrigerated, Water-Cooled, and Vacuum Stills are available in Sizes range from 10 GPH to 100+ GPH capacity.
|
